Light & Space

Dulux Interior Paint Products

Dulux Light & Space A994 Line (Waterbased)

Dulux Light & Space is a premium quality, highly durable and washable emulsion with a soft-sheen finish.

Dulux Light & Space is suitable for all normal interior wall and ceiling surfaces but is not suitable for use in areas subject to frequent or heavy condensation as in some kitchens and bathrooms.

Highly washable surfaces.
Gives an attractive soft sheen finish.
With LumiTecâ„¢ Technology that reflects up to twice as much light, making your room brighter and more spacious.
Allow you to save lighting energy up to 20%.

PACK SIZE 5 litres only.

COLOUR RANGERefer to Dulux Colour Inspirations.

Download Product Information

Water Resistance

Will tolerate the levels of atmospheric humidity present in normal interior environments. Not suitable where frequent heavy condensation is likely, as in kitchens and bathrooms.
THEORECTICAL COVERAGE A guide to the theoretical coverage which can be achieved under normal conditions is 9-10 m²/litre.
COMPOSITION(nominal) Pigment : Lightfast Non-Lead Pigments and Mineral Extenders.
Blinder : PVA Copolymer Emulsion.
Solvent : Water.
VOLUME SOLIDS White 35% (nominal), other colours will vary
Brush or Roller

Conventional Spray
Airless Spray

For sealing new or bare surfaces thin with up to 1 part of clean water to 5 parts of paint (20%).
For normal use, thinning is usually not necessary. If required, should not exceed 1 part of clean water to 10 parts of paint (10%).
Add up to 1 part of clean water to 5 parts of paint (20%).
Ready for use.
Conventional Spray
Airless Spray

Satisfactory through most equipment.
A typical set up for airless spray application would be a minimum working pressure on paint of 140Kg/cm² (2000 lb/sq in) with a spray tip size 0.38mm (15 thou) and a spray tip angle 65°
Touch Dry
Single coat at standard thickness:
Dependant on temperature and humidity.
1- 2 hours.
CLEANING UP Clean all equipment with clean water immediately after use.
SURFACE PREPARATION Surfaces must be sound, clean, dry and free from all defective or poorly adhering material, dirt, grease or wax and be thoroughly rubbed down using a suitable abrasive paper and dusted off. If after thorough preparation, surfaces remain powdery, seal with one coat of an appropriate Primer. (See below)
Powdery Surfaces

Alkaline and New Surfaces

Normal, Sound Surfaces
Dulux Adhesion Promoting Interior Wall Primer (A579 - 15458)
Dulux Alkali Resisting Interior Wall Sealer (A931 - 18380)
No Primer Required.

Dulux Light & Space (A994)
  • Keep out of the reach of children
  • Do not breathe vapour/spray
  • Use only in well ventilated areas
  • Safety data sheet available for professional user on request.
  • Avoid contact with skin or eyes
  • If swallowed seek medical advice immediately and show this container or label.
  • Dry sanding, flame cutting and/or welding of the dry paint film will give rise to dust and/or hazardous fumes. Wet [sanding]/[flatting] should be used wherever possible. If exposure cannot be avoided by the provision of local exhaust ventilation, suitable respiratory protective equipment should be used
  • Do not use empty container for storing food.
  • Remove as much paints as possible from brushes and rollers before cleaning.
  • Keep away from food, drinks and animal feed.
  • Store in a cool and shaded place.
  • Container must be in a secure, upright position and be tightly closed.
  • In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
  • In case of contact with skin wash immediately with soap and water or a proprietary skin cleanser. Do not use solvents or thinners.
  • Wear eye/hand protection.
  • Avoid release to environment. Refer to special instructions/Safety data sheet.
  • Do not empty into water course.
  • Dispose of used container in compliance with local regulation.
  • Refer to Dulux Product Safety Data Sheet for further details.
  • In case of emergency, refer to Emergency Incident Response Hotline 1-800-80-6187